test Literal
Email text


A-Z of Mesh Technology

Warp and Weft

The longitudinal direction of the mesh is known as warp, and the transverse direction weft. We use only stainless steel wires capable of withstanding the most challenging demands in terms of diameter tolerances, yield limits and wire surface quality.


Mesh opening and wire diameter

Bopp Bild
Square weave steel meshes are defined by mesh opening and wire diameter. The mesh opening (w) is the distance between two warp or weft wires. The wire diameter (d) is the wire gauge prior to weaving. This diameter can change slightly during the weaving process.

Mesh count

Bopp Bild Bopp Bild
The mesh count is the number of picks per (Imperial) inch and is calculated as follows:

Open area

Bopp Bild
The term ‘open area’ describes the percentage part of all apertures across the entire surface area of the mesh.


Mesh thickness

Bopp Bild
The mesh thickness is calculated from the wire diameter and the style of weave. The thickness measurement is taken with the mesh not under tension using a disc sensor, measuring pressure 1.8N, on a rigid base. Dependent upon mesh type, tolerances for uncalendered meshes lie between +/- 2 to +/- 5 microns. Within the roll, tolerances are considerably lower.

Geometric Pore Size

Bopp Bild
The geometric pore size is a calculated value which is based on characteristic parameters such as weave structure, wire diameter and pitch. The geometric pore size describes the diameter of the largest sphere, which can just pass through the fabric. The calculation equations were developed and validated experimentally by the IMVT Institute of the University of Stuttgart as part of the AVIF projects A224 and A251. For some weave specifications, where these equations are not valid, the pore size was determined in a dry glass bead test.

Types of weave

Plain weave

Bopp Bild
This is the most commonly used type of weave. Each alternate wire is woven in, and the warp and weft wires alternate in crossing over and under each other, thus locking into position. Smooth weave meshes guarantee exceptionally precise aperture sizes. This type of weave uses wires which are thinner than the resultant apertures.

Twilled weave

Bopp Bild
This mesh type is chosen where a greater wire thickness is required in relation to the aperture size, which could not withstand the weaving process. Here, at least two wires are woven in together with successive displacement around a single wire. The stability of the weave is dependent upon the correct combination of aperture size and wire gauge, and presents a slightly diagonal course. Using modern weaving technology, excellent levels of stability can be achieved.

Theoretical ink volume Vth

Bopp Bild
The theoretical ink volume describes the volume of the open apertures calculated against the substrate surface. Where the ink volume is inadequate, a mesh with a higher Vth should be used.

Screen tensioning

Ideal tensioning values are dependent upon the application. The values given in our specifications are recommendations. Please refer to the data in this link.


Square weave mesh in plain or twilled weave


FILTER cloths (dutch weaves)


Specific weights (options = standard)

For materials other than iron and steel calculation of the weight of the wire cloth is carried out in kg/m2 using the following multiplication factors, or according to the actual specific weight (density).


Please select a contact person and send us your inquiry

Technical Sales Manager
Tel.: 704 249 9974

Technical Sales Manager
Tel.: 434 219 9800

Tel.: +1 845 296 1065